Note that this Wiki is a work in progress, items may not be updated or may disappear entirely as the pages are updated.
SimpleCast General Options
From SpacialAudio
This is a screen shown in the Configure Window in SimpleCast.
General Options
Automatically start on load - When SimpleCast is loaded, SimpleCast will automatically start recording the audio and enable the SimpleCast event adaptors.
- Note: This does not automatically start the encoders. Encoders must be configured to start automatically from the encoder configuration.
Capture sound from device - This is the audio device (soundcard) which SimpleCast will use to capture the sound from. Remember, the soundcard recording mixer control must already be set to record from the correct source.
- I.E.: If your audio is being passed into the Line-in of your soundcard, the line-in recording control must be selected in your soundcard mixer:
- On your Windows Taskbar, there should be a speaker. Double-Click on that speaker and a box will pop up (alternatively you can go to Run, and type in "sndvol32" and a window will pop up):
- In the Volume Control Box, click on "Options" then "Properties"
- Click on Recording
- Checkmark all in the White Box (Volume Controls)
- Click OK
- Select "Line-in" (or something that allows for mixing of your Line-in)
- On your Windows Taskbar, there should be a speaker. Double-Click on that speaker and a box will pop up (alternatively you can go to Run, and type in "sndvol32" and a window will pop up):
Logging - [x] Save log to file If enabled, SimpleCast will log all events to a file (specified directly below). This can help debug any problems that may occur during the usage of SimpleCast.
Maximum log size - The maximum allowed size of the log file. Once the log files reaches this size, it will be deleted and a new log file will be started.
